Category: ANSI Standards

ANSI CAN IAPMO Z1349-2021 pdf download.Devices for Detection, Monitoring or Control of Plumbing Systems 1.1.1  This standard covers devices for detection, monitoring or control of water supply and distribution systems in sizes DN 8 to DN 300 […]

ANSI C78.43-2017 pdf download.American National Standard for Electric Lamps— Single-Ended Metal Halide Lamps 1 Scope This standard sets forth the physical and electrical requirements for single-ended metal halide lamps operated […]

ANSI C63.27-2017 pdf download.American National Standard for Evaluation of Wireless Coexistence 5.5.2 EUT special functionality The EUT could have special functionality to enhance its capabilities， such as multiple-input, multiple-output (MIMO)， […]

ANSI C63.25.1-2018 pdf download.American National Standard Validation Methods for Radiated Emission Test Sites, 1 GHz to 18 GHz . 5.2.3 Measurement procedure a) Set the start and stop frequencies on […]

ANSI C63.15-2017 pdf download.American National Standard Recommended Practice for the Immunity Measurement of Electrical and Electronic Equipment 5.3.1 General This test method is used to verify the ability of the […]

ANSI C63.4A-2017 pdf download.American National Standard for Methods of Measurement of Radio- Noise Emissions from Low-Voltage Electrical and Electronic Equipment in the Range of 9 kHz to 40 GHz NOTE […]

ANSI BHMA A156.18-2000 pdf download.AMERICAN NATIONAL STANDARD FOR MATERIALS AND FINISHES 3.1.2  Components without surfaces which  are  compatible with the prescribed test methods, shall use  a finished flat test panel  […]

ANSI BHMA A156.8-2000 pdf download.AMERICAN NATIONAL STANDARD FOR CDOOR CONTROL – OVERHEADS TOPS AND HOLDERS 2.1 Test Procedures 2.1.1 All tests shall be performed on doors 36 inx 84 inx […]

ANSI B175.4-2018 pdf download.Portable, Handheld, Internal Combustion Engine-Powered Cut-Off Machines – Safety and Environmental Requirements 4.3. Engine stopping device The engine shall be fitted with an on/off or stop control, […]

ANSI B151.5-2000 pdf download.for Plastic Film and Sheet Winding Machinery – Manufacture, Care and Use 1.3.1 New Installation The requirements of this standard pertaining to manufacture shall apply to all […]